Search for: All records

Two-thirds of the Earth is covered by mid-ocean ridge basalts, which form along a network of divergent plate margins. Basalts along these margins display a chemical diversity, which is consequent to a complex interplay of partial mantle melting in the upper mantle and magmatic differentiation processes in lower crustal levels. Igneous differentiation (crystal fractionation, partial melting) and source heterogeneity, in general, are key drivers creating variable chemistry in mid-ocean ridge basalts. This variability is reflected in iron isotope systematics (expressed as δ⁵⁷Fe), showing a total range of 0.2 ‰ from δ⁵⁷Fe =  + 0.05 to + 0.25 ‰. Respective contributions of source heterogeneity and magma differentiation leading to this diversity, however, remain elusive. This study investigates the iron isotope systematics in basalts from the ultraslow spreading Gakkel Ridge in the Arctic Ocean and compares them to existing data from the fast spreading East Pacific Rise ridge. Results indicate that Gakkel lavas are driven to heavier iron isotope compositions through partial melting processes, whereas effects of igneous differentiation are minor. This is in stark contrast to fast spreading ridges showing reversed effects of near negligible partial melting effects followed by large isotope fractionation along the liquid line of descent. Gakkel lavas further reveal mantle heterogeneity that is superimposed on the igneous differentiation effects, showing that upper mantle Fe isotope heterogeneity can be transmitted into erupting basalts in the absence of homogenisation processes in sub-oceanic magma chambers.

Drilling 809‐m Hole U1473A in the gabbro batholith at the Atlantis Bank Oceanic Core Complex (OCC) found two felsic vein generations: late magmatic fractionates, rich in deuteric water, hosted by oxide gabbros, and anatectic veins associated with dike intrusion and introduction of seawater‐derived volatiles. Microtextures show a change from compressional to tensional stress during vein formation. Temperatures and oxidation state were obtained from amphibole‐plagioclase and oxide pairs in the adjacent gabbros. Type I veins generally have reverse shear‐sense, with restricted ΔFMQ, high Mt/Ilm ratios, and low‐amphibole Cl/F indicating deuteric fluids. They formed during percolation and fractionation of Fe‐Ti‐rich melts into the primary olivine gabbro. Type II veins are usually hosted by olivine gabbro, occur at dike contacts and the margins of normal‐sense shear zones. They are undeformed or weakly deformed, with highly variable ΔFMQ, low Mt/Ilm ratios, and high‐amphibole Cl/F, indicating seawater‐derived fluids. The detachment fault on which the gabbro massif was emplaced rooted near the base of the dike‐gabbro transition beneath the rift valley. The ingress of seawater volatiles began at >800°C and penetrated at least ~590 m into the lower crust during extensional faulting in the rift valley and adjacent rift mountains. The sequence of the felsic vein formation likely reflects asymmetric diapiric flow, with a reversal of the stress regime, and a transition from juvenile to seawater‐derived volatiles. This, in turn, is consistent with fault capture leading to the large asymmetries in spreading rates during OCC formations and heat flow beneath the rift mountains.

Fast diffusing Li isotopes provide important insights into the “recent” transient events or processes for both modern and ancient times, but questions remain concerning the large Li isotopic variations of mantle peridotites, which greatly hampers their usage as a geochemical tracer. This study investigates in situ Li content and isotopic profiles of the constituent minerals of abyssal peridotites from the Gakkel Ridge and Southwest Indian Ridge. The complicated and large variations of Li isotopic profiles in Clinopyroxene (Cpx) and Orthopyroxene (Opx) indicate Li isotopic disequilibrium at millimeter scale. The negative correlations of a wide range of Li contents (0.5 to 6.5 ppm) and δ⁷Li values (−10 to +20‰) of olivine, Opx and Cpx grains/relicts, trace element zoning of Cpx, the occurrence of plagioclase, olivine serpentinization along cracks, together with numerical modeling demonstrate the observed Li characteristics to be a manifestation of high‐temperature mineral‐melt Li diffusion during melt impregnation overprinted by low‐temperature mineral‐fluid Li diffusion during dissolution and serpentinization. The preservation of the Li isotopic diffusion profiles requires rapid cooling of 0.3–5°C/year after final‐stage melt impregnation at the Moho boundary, which is consistent with the low temperature at very slow spreadin g ridges caused by conductive cooling. Compared with the well‐studied melt‐rock interaction process, our study indicates that low‐temperature fluid‐rock interaction can induce Li diffusion even in the visibly unaltered mineral relicts of partially altered rocks.